INCH-POUND
MIL-DTL-46177C(MR)
24 October 1998
SUPERSEDING
MIL-A-46177B(MR)
19 October 1990
DETAIL SPECIFICATION
ARMOR, STEEL PLATE AND SHEET, WROUGHT, HOMOGENEOUS
(1/8 TO LESS THAN 1/4 INCH THICK)
This specification is approved for use by the U.S. Army Research Laboratory,
Department of the Army, and is available for use by all Departments and
Agencies of the Department of Defense.
1.
SCOPE
1.1 Scope. This specification covers wrought-steel homogeneous plate and sheet
from l/8 to less than l/4 inch inclusive in thickness (see 6.2).
2.
APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are specified in sections 3
and 4 of this specification. This section does not include documents in other
sections of this specification or recommended for additional information or as
examples. While every effort has been made to ensure the completeness of this
list, document users are cautioned that they must meet all specified requirements
documents cited in sections 3 and 4 of this specification, whether or not they
are listed.
2.2
Government documents.
2.2.1 Specifications, standards, and handbooks. The following specifications,
standards, and handbooks form a part of this document to the extent specified
herein. Unless otherwise specified, the issues of these documents are those
listed in the issue of the Department of Defense Index of Specifications and
Standards (DoDISS) and supplement thereto, cited in the solicitation (see 6.2).
STANDARDS
DEPARTMENT OF DEFENSE
MIL-STD-662
V50 Ballistic Test for Armor
(Unless otherwise indicated, copies of the above specifications, standards, and
handbooks are available from the Defense Automated Printing Service (DAPS),
Building 4D, 700 Robbins Avenue, Philadelphia, PA 19111-5094.)
Beneficial comments (recommendations, additions, deletions) and any pertinent
data which may be of use in improving this document should be addressed to:
Director, U.S. Army Research Laboratory, Weapons and Materials Research
Directorate, ATTN: AMSRL-WM-M, Aberdeen Proving Ground, MD 21005-5069 by using
the Standardization Document Improvement Proposal (DD Form 1426) appearing at the
end of this document or by letter.
AMSC N/A
FSC 9515
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business